Installing The Projector; Disassemble The Parts - Epson BrightLink 475wi+ Guia De Instalacion

5 Installing the Projector

Make sure to follow the steps below to install the wall mount. If you ignore these steps, the wall mount could
fall and cause personal injury or property damage.
Warning
❏
When you mount the projector on the wall with the wall mount, the wall requires enough
strength to hold the projector and the wall mount.
This wall mount should be installed on a concrete wall. Confirm the weight of the projector
and the wall mount before installation, and maintain the strength of the wall. If the wall is
not strong enough, reinforce the wall before installation.
❏
The combined weight of the projector and the wall mount is 32 lb (14.5 kg).
❏
Do not hang the rest of the cable over the wall mount.
❏
Install the wall mount so that it can sufficiently support the weight of the projector and
wall mount, and resist any horizontal vibration. Use M8 nuts and bolts. Nuts and bolts
smaller than M8 could cause the wall mount to fall.
❏
Epson accepts no responsibility for any damage or injury caused by lack of wall strength or
inadequate installation.
A

Disassemble the parts

1. Remove the wall plate from the wall mount arm.
•
Remove the M6 × 20 mm hexagon shoulder bolt (
•
Remove the M6 × 20 mm cross recessed head shoulder screws (×3) with the No.3 cross-head
screwdriver (
M6 × 20 mm cross
recessed head shoulder
screws (×3)
).
).
18
M6 × 20 mm hexagon
shoulder bolt