Descargar Imprimir esta página

Eldom Invest WV03039 Instrucciones De Montaje, Uso Y Mantenimiento página 13

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 84
EN
When you are not certain about the temperature in the room where the water
heater is installed, i.e. that it may fall below 0°C, the water from the water
tank MUST be drained - please refer to section 'CONNECTION TO THE
WATER SUPPLY NETWORK'
The water heater outer shell and plastic parts can be cleaned using only a
slightly damp soft cotton cloth and never with invasive and/or abrasive
substances and preparations. Before cleaning the appliance, it MUST be
disconnected from the power supply with the additional disconnection device
or by unplugging the plug on the power cord. IT IS FORBIDDEN to clean the
appliance with steam generator. Particular attention should be paid to prevent
wetting of the appliance light switch on its control panel. The water heater may
be switched on in operation only after complete removal of moisture.
The rules for checking the corrosion protection and anode replacement
(please refer to previous section), as well as removal of the accumulated
limestone, must be strictly observed both during and after the appliance
warranty period.
During the appliance usage and maintenance do not damage the metal
plate with its technical data and serial number. Should you take it off, keep it
with the warranty form because it is the document serving to identify the
water heater.
FAILURES
When the heater does not heat the water, check if the external disconnecting
device is not switched off, if the lighting key is switched off and if the
thermostat knob is not turned to the lowest position.
If the power supply is in order, the lighting key is switched on and the
thermostat knob is turned to its highest position, but the water in the
appliance is still not warming (it is possible that the lighting key or the signal
lamp are lighted or not), using the external disconnecting device unplug the
heater and contact the nearest authorized service company.
In case when from the mixer at completely open tap for hot water there is no
leakage or water flow is weak, check if the filter at the mixer outlet is not
clogged, or whether the shut-off valve before the heater is not fully or
partially closed (4, Fig. 8), or if water supply is not stopped. If all listed above
causes are not the cause of failure, using the external disconnecting device
unplug the heater and contact the nearest authorized service company.
When the water heater is equipped with electronic control board, at the end
of the additional instruction manual are listed the error messages appearing
on the display in case of failure and what measures to take for each case. In
any other general case of failure, using the external disconnecting device
unplug the heater and contact the nearest authorized service company.
In case of failure of the power cord and/or plug for water heaters with such,
contact the nearest authorized by the manufacturer service company as the
cord with plug must be replaced by the manufacturer, its service agent, or a
person with similar qualifications in order to avoid danger.
WA R R A N T Y, WA R R A N T Y P E R I O D A N D
WARRANTY CONDITIONS
The warranty, warranty conditions, warranty period, warranty validity for
purchased appliance and service related manufacturer or vendor liabilities
during the appliance warranty period are listed in the appliance warranty
form. When buying the appliance the warranty form must be filled and
signed both by seller and buyer. Keep the warranty form in a secure place.
In all instances shall be in force the applicable laws, regulations and other
legislation dealing with the rights and obligations of consumer, seller and
manufacturer, and their relationships related to purchased water heater, its
installation, use, servicing and maintenance.
Warranty term is determined by seller and is in force only for the
geographical territory of the country.
Warranty is valid only if the appliance:
Is installed according to the requirements for installation and
џ
operation.
Is used only as per designed purpose and in accordance with the
џ
installation and operation manual.
Warranty consists of free of charge repair of all factory defects, which may
arise during the warranty term. Repair is performed by service specialists,
authorized by seller.
Warranty is not valid for damages, caused by:
Improper transportation
џ
Improper storage
џ
Improper usage
џ
Parameters of water, different from the admissible norms for quality of
џ
drinking water, and particularly if the composition of chlorides is more
than 250 mg/l; the electrical conductivity is less than 100 μS/cm and
pH is outside of 6,5-8 for water heaters with enameled water tanks; the
electrical conductivity is more than 200 μS/cm for water heaters with
water tanks made of chrome-nickel steel.
Supply voltage, different than the unit's rated voltage.
џ
Damages due to freezing of water.
џ
Elemental perils, disasters and other force majeure circumstances.
џ
Non observance of the installation and operation manual.
џ
In cases, when a non authorized person has tried to repair any kind of
џ
a defect.
In the above cases the defect will be repaired against relative payment.
Warranty shall not apply to normal wear parts and components of the
device, parts that are being removed during normal use, lighting and signal
lamps and the like, changing the color of external surfaces, change of
shape, size and location of parts and components that are exposed to
impact and conditions that are not considered normal use.
Lost profits, tangible and intangible damages caused by temporary inability
to use the device during its prevention and repair shall not by covered by the
warranty.
COMPLIANCE WITH THE REQUIREMENTS OF THIS
INSTRUCTION MANUAL IS A PREREQUISITE FOR SAFE
OPERATION OF YOUR PURCHASED PRODUCT AND IS ONE OF
THE WARRANTY TERMS AND CONDITIONS.
IT IS ABSOLUTELY PROHIBITED TO THE USER OR ANY
AUTHORIZED BY HIM PERSON TO UNDERTAKE ANY CHANGES
IN THE PRODUCT DESIGN AND STRUCTURE. ANY FINDING OF
SUCH ACTIONS OR ATTEMPTS SHALL AUTOMATICALLY
RENDER VOID ALL WARRANTY LIABILITIES OF SELLER OR
PRODUCER.
IN CASE OF NECESSITY FOR SERVICE SEEK ONLY
MANUFACTURER AUTHORIZED SERVICE COMPANIES LISTED
IN THE ANNEXED FORM.
T H E M A N U FA C T U R E R P R E S E RV E D H I S R I G H T TO
STRUCTURAL CHANGES WITHOUT NOTICE WHERE SUCH
SHALL NOT AFFECT PRODUCT SAFETY.
EN

Publicidad

loading