Timken VHIN-G3-35 Manual De Instrucciones página 19

Default max speed:
6.3 Explanation of system settings – screen 2
Default
Temperature hold:
6.4 Explanation of system settings – screen 3
Offset Temperature
probe 1:
Offset Temperature
probe 2:
Unit:
Language:
Maximum setpoint, maximum heating speed in the temp&speed modes.
This does not mean that the heater will always reach this speed. This
depends, among other things, on the geometry of the workpiece, the
yoke used, etc.
Default temperature hold on or off
Calibration / correction readout thermocouple 1
Calibration / correction readout thermocouple 2
Setting of the temperature measurement in °C or °F.
Setting of the language in which the texts on the screen are displayed.
Choice of Dutch, English, German and Italian.
EN
DE
ES
FR
NL
19