Timken VHIN-G3-35 Manual De Instrucciones página 31

9.3 Heating in time mode
•
Position the workpiece and any sensors (according to chapters 7 & 8.) Only use the sensor if
you want to check the temperature before the countdown has completed.
•
Switch on the heater and select the time mode if necessary.
•
If necessary, change the time set by pressing the current time.
•
Press "START". The heating starts, you will hear a slight humming sound.
•
The display shows the time left until process completion.
If you have connected the sensors and placed them on the workpiece, the temperatures measured
are also shown on the display.
NOTE!
In time mode, the process does nothing with these temperatures!
EN
DE
ES
FR
NL
31