Timken VHIN-G3-35 Manual De Instrucciones página 34

By pressing the info button
The white dotted line indicates the gradient at which the process is set. Pressing info again
displays additional information from the process.
•
Unless the thermostat function is switched on, heating will stop automatically when the set
temperature is reached. A loud beep sounds, and the display shows information about how
the heating process went. The beep can be ended by pressing "STOP".
•
When the thermostat function is switched on, unless you press "STOP", the workpiece will be
kept at the set temperature for the time set. Heating starts again after the temperature has
dropped to the temperature set in the system settings to which the workpiece is allowed to
drop. Each time the set temperature is reached, the induction heater sounds a loud beep.
•
During this cycle, a clock is displayed at the bottom of the screen with the time remaining for
the temperature hold mode. After the temperature hold time has elapsed, the heater sounds a
continued loud beep, which can be ended by pressing "STOP".
•
Each time the induction heater stops, it automatically demagnetises the workpiece.
•
The heating process or thermostat feature can be interrupted by pressing the "STOP" button.
9.6 Workpiece handling
•
After pressing "STOP", place the sensor(s) on the side of the pole.
•
By pressing "STOP", the workpiece is demagnetised automatically.
•
Wear heat-resistant gloves. Place the yoke with the workpiece on a clean surface or if the
heater is equipped with a swivel arm, swivel the yoke forwards into the positioning cam, slide
the workpiece off.
•
Fit the workpiece without delay and prevent cooling down.
34
, the heating process is displayed graphically.