Timken VHIN-G3-35 Manual De Instrucciones página 45

This functionality enables a workpiece to be held at a set temperature once that temperature
has been reached. Maintaining the temperature of a workpiece follows a certain switching
hysteresis (T hold hysteresis), which can be set in the system settings as described in section 6.4.
The temperature set here is the temperature to which a workpiece may drop before the heater
switches on again automatically.
When the Hold Temp functionality is activated, the slider turns green and the hold temp duration
of the workpiece is displayed.
By pressing "Hold Time" you can adjust the hold temp duration of the workpiece. The time is
entered in mm:ss and can be set between 00:01 and 99:00.
After adjusting the time, press 'back / previous screen'
settings, the workpiece is heated to 80°C and then kept at 80°C for 1 minute.
to return. According to the above
EN
DE
ES
FR
NL
45