Timken VHIN-G3-35 Manual De Instrucciones página 33

By pressing the info button
displays additional information from the process.
•
Heating runs until the set temperature is reached or until the set time has elapsed, whichever
comes first. The workpiece is then demagnetised automatically and a loud, continuous beep
sounds. Press "STOP" to switch off the beep.
9.5 Heating in temperature & speed mode
•
Position the workpiece and any sensors (according to chapters 7 & 8.)
•
Switch on the heater and select the temperature & speed mode if necessary.
•
If necessary, change the temperature and gradient set by pressing the current values.
•
Press "START". The heating starts, you will hear a slight humming sound.
•
The display shows the current temperature of the workpiece.
•
If a second sensor is attached to the workpiece, this temperature also appears on the display.
, the heating process is displayed graphically. Pressing info again
EN
DE
ES
FR
NL
33