Timken VHIN-G3-35 Manual De Instrucciones página 30

•
If necessary, change the temperature set by pressing the current temperature.
•
If desired, switch on the "hold temp. " (thermostat mode) and log functionality by moving the
sliders to the right. These will now turn green.
•
Press "START". The heating starts, you will hear a slight humming sound.
•
The display shows the current temperature of the workpiece.
•
If a second sensor is attached to the workpiece, this temperature also appears on the display.
By pressing the info button
displays additional information from the process.
•
Unless the thermostat function is switched on, heating will stop automatically when the set
temperature is reached. A loud beep sounds, and the display shows information about how
the heating process went. The beep can be ended by pressing "STOP".
•
When the thermostat function is switched on, unless you press "STOP", the workpiece will be
kept at the set temperature for the time set. Heating starts again after the temperature has
dropped to the temperature set in the system settings to which the workpiece is allowed to
drop. Each time the set temperature is reached, the induction heater sounds a loud beep.
•
During this cycle, a clock is displayed at the bottom of the screen with the time remaining for
the temperature hold mode. After the temperature hold time has elapsed, the heater sounds a
continued loud beep, which can be ended by pressing "STOP".
•
Each time the induction heater stops, it automatically demagnetises the workpiece.
•
The heating process or thermostat feature can be interrupted by pressing "STOP".
30
, the heating process is displayed graphically. Pressing info again