Timken VHIN-G3-35 Manual De Instrucciones página 51

Models with vertical yoke:
1. Remove dirt, burrs, etc., from the yoke and poles and lubricate lightly.
2. Place the yoke in front of the poles.
3. Loosen the bolts on the yoke by about half a turn.
4. Switch on the heater by pressing start. The yoke now sets itself. If necessary, a plastic (dead
blow) hammer may be used.
5. When noise reduces, then tighten all bolts and switch off the heater.
3
WARNING!
Failure to observe the following warnings could create a risk of death
or serious injury.
•
Always use proper maintenance practices and follow the instructions provided with
this equipment.
•
Contact your supplier if in doubt about the correct functioning of the device.
•
Repairs must be carried out by the manufacturer or a specialist approved by the manufacturer.
4
EN
DE
ES
FR
NL
5
51