cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 125

Removing the transport screws (Fig. 3)
- The transport screws must be removed from the backside of the device before
installing it.
- IMPORTANT: it is imperative to remove the transport screws before the first use,
otherwise they may damage the drum during the operation of the device.
- The transport screws will be necessary again when moving the product, so make sure
they are kept in a safe place.
- In order to remove the screws:
- Loosen 4 screws with a spanner and then remove them (A).
- Remove the 4 tube spacers (depending on model) (B).
- NOTE: during removal of the transport screws, occasionally the pipe spacers may fall
into the machine, if this happens, they can be accessed by tilting the machine forward
and picking them up from the floor or inside the base of the machine.
- Cover the transport screw holes with the 4 supplied plugs (C).
- Keep the transport screws properly for future use. You will need them again if the
washer dryer needs to be moved to another location.
- If it is necessary to transport it to another location:
1. Reinstall the transport screws.
2. Secure the power cable to the rear of the appliance.
Levelling the washer dryer
The appliance reaches high spin speeds to remove water at the end of the wash cycle.
Therefore, it is important that it is level and that all 4 legs press against the floor with the
same pressure.
This will help to ensure quieter operation and less vibration.
Carry out the following steps:
- Install the appliance on a solid, level surface. Preferably in a corner of the room.
- If the floor is uneven, adjust the legs as necessary to level the device. Do not place any
objects under the legs in an attempt to level it.
- Do not extend the legs more than necessary. The more extended, the more vibrations
the device will suffer. Start with the legs all the way in and adjust each one as
BOLERO WASH&DRY 10680 INVERTER B / STEEL B
ENGLISH
125