cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 13

- As a safety measure, we advise you to unplug the
appliance and cut the water supply after every use.
Maximum water-inlet pressure: 1 MPa. Minimum water-
inlet pressure: 0.03 MPa.
- Never unplug the appliance with wet hands.
- To ensure your safety, power plug must be inserted into
an earthed three-pole socket. Check carefully and make
sure that your socket is properly and reliably earthed.
- It must be possible to disconnect the appliance from the
power supply by unplugging it if the plug is accessible, or
by means of an all-pole switch upstream of the plug, in
accordance with national electrical safety regulations.
- The maximum current of the device is 10 A, make sure
that the power supply system (voltage, current and cable)
is applicable to the load of the device.
- Make sure that the socket outlet can support the
Maximum Power rating of the appliance as indicated on
the rating plate.
- Water and electrical devices must be connected
by a qualified technician in accordance with the
manufacturer's instructions and local safety regulations.
- The glass door may reach high temperatures during
operation. Keep children and pets away from the glass
door. Never open the door during the drying stage.
- Do not operate the device in very wet rooms or in rooms
with explosive or caustic gas.
- Adequate ventilation must be provided to avoid the back
flow of gases into the room from appliances burning
other fuels, including open fires.
BOLERO WASH&DRY 10680 INVERTER B / STEEL B 13