cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 127

- Minimum 60 cm (24 inches)
- Maximum 100 cm (39 inches)
Drainage connection types:
1) To the vertical drainage pipe
Connect the drain hose to the elbow (not included) of the drain pipe. Place the elbow on
the hose 4 inches (100 mm) from the end of the hose. Insert this section of hose into the
pipe. If the hose is pushed down too far, it can cause the washer dryer to self-siphon, i.e.
to continuously empty as it fills with water. Secure the elbow and hose with a hose clamp
(not included) to prevent the hose from slipping out of the tube during use.
Fig. 9
1. Drainage pipe
2. Cold water
2) To the sink trap
Secure the drain hose to the sink trap using a 0.9-1.6 inch (20-44 mm) hose clamp. Not
included. Available in hardware or specialised shops. Fig. 10
3) To a sink/washbasin
WARNING: DANGER OF BURNS
When washing at high temperatures, there is a risk of burns when touching hot soapy
water, e.g. when draining hot water with foam into the sink/washbasin. Do not touch hot
soapy water.
Note:
Damage to the appliance / damage to textiles.
If the end of the drain hose touches the water drained by the washer dryer, water can be
sucked back into the washer and damage the appliance or the laundry inside the drum.
To ensure that this does not happen, make sure that:
- No plug in the sink/washbasin drain.
- The end of the drain hose does not touch the drained water.
- Water flows freely through the sink/washbasin drain and there are no blockages.
- The hose is securely connected.
BOLERO WASH&DRY 10680 INVERTER B / STEEL B
ENGLISH
127