cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 126

ENGLISH
necessary.
- You can use a spirit level (not included) to check that the appliance is level.
- Press down on each corner of the top of the equipment to ensure that it does not
"wobble".
- All legs must press equally against the floor.
- When the device is level and does not wobble, lock the legs by tightening the lock nuts
against the bottom of the equipment. Be sure to do this without changing the height of
the leg (hold the leg while tightening the lock nut). Fig. 5
Connection of the supplied hoses
Water supply hose connection
1. Connect one end of the water supply hose to a cold water tap and tighten by hand (Fig.
6). Before making the connection, allow the water to run freely until it runs completely
clear.
2. Connect the other end of the water supply hose to the water inlet valve at the rear by
turning clockwise (Fig. 7).
3. Open the tap slowly and make sure there are no water leaks.
Warning
- Do not kink, crush, modify or sever the water supply hose.
- Squeeze the end of the hose firmly by hand.
- The water supply pressure must be within a range between 0.03 and 1 MPa. If
the pressure exceeds this value, a pressure reducing valve (not included) must be
installed.
- If the hose is not long enough, please contact a specialised retailer, an authorised
technician or the Cecotec Service Centre.
- Never use a second-hand or used hose. Always use the hose supplied with the
equipment.
Drain hose connection
Drainage point height (Fig. 8)
Height difference between the floor and the drain:
126 BOLERO WASH&DRY 10680 INVERTER B / STEEL B