cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 128

ENGLISH
Note:
- Do not twist, pull or bend the drain hose.
- Fix the hose with a hose clamp to the drainpipe, sink/washbasin, etc., so that the hose
will not be forced out by the force of the water.
- For added safety, you can also use a drain hose holder (not included) and install the
hose over a sink/washbasin or tank, as shown in Figure 11.
- The use of hose extensions is not recommended; if absolutely necessary, the
extension should have the same diameter as the original hose and should not exceed
250 cm in length (Fig. 12).
- If drain hose is too long, do not force it into washing machine as it will cause abnormal
noises.
- After installation, wait a few hours before operating the appliance to allow it to
acclimatise to the ambient conditions in the room.
- Only connect the device when the installation has been completed.
4. OPERATION
Note
- Before washing the clothes for the first time, the product shall be operated in one
round of the whole procedures without the clothes inside.
Control panel
A: Wash cycle button/selector
Used to programme the desired wash cycle.
OFF position: turn the wash cycle selector, when the indicator light below the symbol
is on, the machine will stop running and turn off. If the machine is switched off during
a wash cycle, the wash cycle will be cancelled.
B: TEMP
Press the button to change the water temperature of the selected cycle, the temperature
value will appear on the display.
C: SPEED
Press the button to change the spin speed of the selected cycle, the speed value will
128 BOLERO WASH&DRY 10680 INVERTER B / STEEL B