cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 145

Press the buttons to select the desired option; the indicator light of the corresponding option
will turn on.
Press the button(s) again to cancel the option, the indicator light of the corresponding option
will go out.
If the selected option is incompatible with the configured programme, the incompatibility will
be signalled by a beep of the buzzer and the indicator light of the corresponding option will
flash.
If the selected option is incompatible with a previously configured option, only the most
recent selection shall remain active.
5. Add detergent
Remove the detergent dispenser and add detergent and fabric softener (if applicable) into the
corresponding compartments as described in figure 17.
- Compartment 1: detergent powder
- Compartment 2: liquid detergent (must not exceed the level marked MAX).
- Compartment 3: additives such as softener (must not exceed the level marked MAX).
Observe the dosage recommendations of the detergent/softener manufacturer.
The correct dosage of detergent/softener is important because:
- Optimises the cleaning result.
- Avoid excess detergent residues in your laundry, which can cause skin irritations.
- Saves money by avoiding waste of leftover detergent.
- Protects the washer dryer, preventing calcification of the components.
- It respects the environment by avoiding unnecessary environmental burdens.
Do not use detergents for hand washing as they create too much foam!
Use powder detergent for cotton whites, for pre-washing and for washing at a temperature
over 60 ºC!
When using agglomerated, ropy detergent or additives, before they are poured into
the detergent box, it is suggested to use some water for dilution to prevent the inlet of
detergent box from being blocked and overflowing while filling water.
6. Delayed end
If desired, use this function to end a programme at the programmed time.
BOLERO WASH&DRY 10680 INVERTER B / STEEL B
ENGLISH
145