cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 130

ENGLISH
or out of the drum.
To resume the wash cycle from the point where it was interrupted, close the door and
press the button again.
WARNING: if the water level or water temperature in the drum is too high, the door lock
indicator light will come on and the door could not be opened.
I: STAINS
Press the button to select the type of soiling of the laundry, the washer dryer will
automatically adjust the most optimal way to remove the soiling.
Up to 8 types of soiling can be selected.
M: Display (Fig. 14)
1. Temperature indicator
When a wash cycle is selected, the default temperature value of this programme will
appear on the display, with the temperature indicator light illuminated.
You can change the temperature value by pressing the "TEMP" button. If "- -" is shown
on the display, it means that the washer dryer uses cold water only (the internal heating
element for heating water would not be available in this programme).
2. Rotational speed indicator rpm
When a wash cycle is selected, the default spin speed of this programme will appear on
the display, with the spin speed indicator light illuminated.
You can change the spin speed value by pressing the "SPEED" button. If "- -" is shown on
the display, it means that the washer dryer does not spin after the final draining process in
this programme.
3. Door lock indicator
The lit symbol indicates that the door is locked. To avoid any damage, wait until the icon
turns off before opening the door.
To open the door while a wash cycle is in progress, press the "START/PAUSE" button, if the
"Door Lock" icon is off, the door can be opened.
NOTE: for safety reasons it is not always possible to open the door once the wash cycle
has started.
130 BOLERO WASH&DRY 10680 INVERTER B / STEEL B