cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 153

Machine does not drain,
drains slowly or "E03"
appears on the display.
The wash programme
time stops counting before
entering the high-speed spin
process.
Washing programme lasts
too long
Excessive noise
The machine is continuously
filled with water and
continuously emptied.
The drained water returns to
the apparatus
Control panel gets hot
The top of the drain hose is too high. It should be installed at a
height of 65-100 cm from the ground.
The draining pump filter is blocked.
Drain hose is kinked or bent.
Drain hose is blocked or frozen.
This is not an issue. The load balancing system of the
appliance tumbles and scatters the laundry in the drum
for a long time to achieve balance and complete the high
speed spin. In the process of tumbling and scattering, the
programme time stops counting before the appliance reaches
the high-speed spin process.
Programme times will vary due to water pressure, incoming
water, temperature, etc.
If the wash load becomes unbalanced, the time will increase.
There will always be some noise from the motor, pump and
drum during spinning.
The washer dryer touches other objects.
Foreign objects, such as hairpins or metal objects, fall into the
drum.
The top of the drain hose is too low. It should be installed at a
height of 65-100 cm from the ground.
The end of the drain hose has been pushed too far down into
the standpipe; the hose elbow must be installed 100 mm from
the end of the drain hose.
The end of the drain hose is submerged in the discharged
water.
If the end of the drain hose touches the discharged water
(water drained from the washing machine), it (the discharged
water) may be sucked back into the appliance and damage the
appliance or garments.
This is a slight heating effect of the electronic components on
the PCB board installed on the back of the control panel.
BOLERO WASH&DRY 10680 INVERTER B / STEEL B
ENGLISH
153