Polar Team2 Manual De Uso página 172

Ayuda Polar Team²
connected even if they are inserted
into the charger correctly and there
is a connection between the base
station and the PC.
A transmitter was not found during
Wizard or with Add New
Transmitterfeature.
You have attached the numbered
sticker onto the new transmitters
(transmitter kit) and gone through
Add New Transmitter process. The
numbers that the system gave for
the transmitters don't match the
numbered stickers on the
transmitters.
166
the charger.
2) The transmitters are in non-
secured mode.
1) Transmitter is inserted into
charger incorrectly.
2) Contact problem between the
transmitter and the charger.
3) Problem with the wizard.
and into wall outlet.
2) Change the transmitters' mode to
secured by removing the
transmitters from charger and
inserting them back after a minimum
of 3 seconds. Only one sound
should be heard.
Click Searchto start the search
again and wait until the system has
performed the search. Do this twice.
1) Insert transmitter into the charger
so that the P of Polar logo is not
visible. The led is located next to
the R of Polar logo.
2) Remove the transmitters that
were not found from the charger
and insert them back. You can also
try to insert the transmitters into
another slot of the charger.
3) Finish Wizard and add the rest of
the transmitters with Add New
Transmittersfeature (Tools >Add
New Transmitter).
Either...
1) Remove the numbered stickers
from the transmitters and attach
them onto the correct transmitters.
Or...
2) Cancel the Add New Transmitter
process, remove the transmitters
you added to the system (this time)
from the system (Tools >
Preferences > Transmitters tab),
and add the transmitters to the