Snapper RTX102 Manual Do Utilizador página 93

(continued)
INTERVAL
Air filter and spark plugs
AFTER 50 HOURS
Lubrication
Engine, transmission,
AFTER 100 HOURS
electromagnetic transmission
Tyres
MONTHLY
Mowing deck
Fuel filter
Battery
Travel drive belt
BEFORE THE
SEASON
Mowing deck
Front axle and steering
Engine
AFTER THE
SEASON
Cables
(PUTTING OUT OF
OPERATION)
Mowing deck
Explanations for table:
1 = Replace more frequently if the riding mower is under greater load or works in outdoor temperatures around 35°C or higher.
2 = If the mower works in a dusty environment, perform the inspection more frequently.
3 = Perform the inspection more frequently if the mower works in a sandy environment.
4 = Perform the inspection more often if a new belt has been fitted.
N = Manual of the manufacturer, supplied with the mower.
Apart from regular maintenance according to the above table, it is necessary to replace motor oil based on the recommendations in
the manual drawn up by the engine manufacturer, which is included with the riding mower.
6.2 DAILY CHECKS AND MAINTENANCE
Before starting any maintenance or repair works, thoroughly reacquaint yourself with all instructions, restrictions and recommendations
in this user's manual.
Always remove the key from the ignition and disconnect the spark plug cables before performing any cleaning, maintenance or
repairs.
When working use suitable work clothing and work footwear. Use suitable gloves when handling a mowing blade or for activities
where there is a risk of cuts.
Avoid spilling fuel, oils or other harmful substances.
Do not perform any major repairs if you do not have the necessary tools and a good knowledge about repairs of combustion
engines!
Dispose of used oil, fuel or other hazardous substances and materials in accordance environmental protection regulations in force.
6.2.1 BEFORE STARTING WORK
CHECK THE TYRE PRESSURE
Maintain the prescribed tyre pressure and check it regularly. Maintaining the prescribed tyre pressure is important for even mowing.
Various pressure values may cause difficulty in driving, or even loss of control over the mower.
The air pressure in the front and rear tyres must be in the range 80 - 140 KPa, whilst the differences between individual tyres may
be ± 10 KPa.
CHECK THE OIL LEVEL IN THE ENGINE
Park the riding mower on a horizontal surface. Open the hood and unscrew the cap of the filling opening. Screw out the oil dipstick,
wipe it dry, reinsert it and screw in. Then again screw it out and take the oil level reading.
The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so that it reaches the "FULL" mark.
ASSEMBLY
Inspection, replacement if necessary
Lubrication of parts according to lubrication plan
Inspection and adjustment of motion
Inspection of pressure
Inspection of tension of the cogged blade drive belt
Replacement
Inspection of electrolyte and cleaning
Inspection and adjustment
Inspection of tension of the cogged blade drive belt
Inspection of the correct tension of the mowing deck drive
V-belt
Inspection and adjustment of play
Oil change
Inspection of mounting, inspection of quick coupler parts
Cleaning
93
ACTIVITY
1,2
6.3.2
6.4
N
6.2.1
6.3.9
N
6.3.1
6.3.12
6.3.9
6.3.8
6.3.11
6.3.2
6.2.1
6.2.2