Snapper RPX102 Manual Do Utilizador página 68

UNPACKING
Remove packaging materials. First take out the lid, frame and sack and then the wrapped individual parts. Unpack these parts and
arrange them clearly in a suitable place.
INCLUDED CONTENTS
(1) Lid
(2) Dump lever handle
(3) Front tube
(4) Lower tube
(5) Side struts
(6) Lower brace
(7) Handle
3.5.2a
(8) Sack (mesh)
(9) Frame
(10) Grass catcher hitches
(11) Grass catcher presence sensor contact spring
(12) Rear hitch
(13) Joining material
A part of the grass catcher package are also spare break pins for the cutting blades (4 pcs).
Keep these pins for future use.
VIEW OF THE ASSEMBLED GRASS CATCHER
Positions correspond to the illustration 3.5.2a.
(1) Lid
(2) Dump lever handle
(3) Front tube
(4) Lower tube
(5) Side struts
(6) Lower brace
3.5.2b
(7) Handle
(8) Sack (mesh)
(9) Frame (underneath the lid)
(11) Grass catcher presence sensor contact spring
INSTALLATION OF THE GRASS CATCHER

Screw the grass catcher hinges (10) and the hinge (12) on to the rear plate.
3.5.2c
On some machines, the hinges (10) are already pre-mounted on the rear plate.
Install the hinge (12) only if a trailer is used.

Attach the front tube to the top holes in the brackets using M5×16 nuts and bolts. Screw the grass catcher hitch
switch on to the left bracket of the frame using two M5×16 bolts and fasten using nuts.
3.5.2d

Screw on the side struts of the grass catcher. The struts are attached to the outer side of the grass catcher using
M5×16 bolts and nuts.
3.5.2e

Screw the bottom tube to the front tube and the side struts using M5×25 nuts and bolts. For easier assembly, we
recommend that the grass catcher is turned upside down.
3.5.2f

Slide the grass catcher sack on to the frame. Pull the rubber sides of the sack over the tubes.
3.5.2g
68