VEVOR BL350-19 Manual De Instrucciones página 9

1.5 Speedometer (3): Show the driving speed when driving.
1.6 Power indicator (4): it is a capacity indicator showing the presence of the
battery. When the power door lock is in the "ON" position, the power pointer on the
instrument is rotated to the corresponding position.
During driving, the power is indicated at the H position, indicating that the battery is
sufficient; when the power is near the Red Border area (L), indicating that the
power is insufficient, it should be charged immediately.
1.7 Rearview mirror (11): thus observe whether there are pedestrians and vehicles
behind the left and right sides, to ensure the driving safety when turning or
overtaking.
1.8 Speed transfer (6): located on the right side of the handle, at the start, should
gently turn the speed transfer inside, so that your car at a low speed for a distance.
If you want to increase the acceleration, you should keep turning the governor and
tightening it. If you release the speed knob and return it automatically, your car will
slow down and slide.
When turning the speed transfer, pay attention to avoid the fierce increase of the
speed transfer, try to develop the habit of "light turn light put"
1.9 Electric door lock (8): for the main power switch, is a high current switch, turn
on the electric door lock electric vehicle can electric work. Turn the main power
supply switch to the "ON" position, and the voltmeter pointer is moved to the
corresponding position, then the total power supply is switched on. When parking,
please remove the key to the OFF immediately to avoid damage caused by
accidentally turning to the speed control rotor.
2. Starting from driving:
2.1 Startup:
A. Fold away the single support and double support;
B. Put the key into the switch lock and turn clockwise to the ON position, then the
instrument power indicator is on.
Note: After the main power supply is turned on, the rear wheel is on the ground.
When the rider is not sitting on the cushion, do not turn the speed control knob to
prevent the vehicle from suddenly rushing forward, which can easily cause safety
accidents. When parking, as much as possible to avoid losses caused by
operation error.
2.2 Variable speed:
After electrification, the shift handle can rotate inward (counterclockwise) to
accelerate the vehicle, and rotate the shift handle outward (clockwise) to slow
down the vehicle. When the vehicle starts driving, do not suddenly increase the
speed switch, should gradually turn the speed switch, the speed gradually
accelerated that can save electricity and achieve safe driving.
- 8 -