Kaco blueplanet gridsave 92.0 TL3-S Guía Rápida página 10

1
Fig. 9: Communication circuit board (HMI board)
1 Communication circuit board
2 USB socket
3 SD- Slot
4 Ethernet for network connection DHCP
4.7.2 Ethernet connection
NOTE
The connection plug of an RJ45 cable is larger than the opening of an M25 cable fitting when it is installed.
For this reason, remove the sealing insert before installation and thread the Ethernet cable outside of the
cable fitting through the sealing insert.
NOTE
Use a suitable category 7 network cable. The maximum distance between two devices is 100 m (328 ft). The
Ethernet switch allows for the repeater function and supports auto-sensing. Ensure that the cable is cor-
rectly assigned. You can use both crossed and 1:1 protectively-wired Ethernet connection cables.
↻ Connecting cable inside the device.
1 Plug in an Ethernet cable at one of the two Ethernet ports on the communication circuit board.
2 Check that the connecting cable is fitted securely.
» Connect additional signal cables.
4.8 Sealing the connection area
↻ Grid connection is prepared.
1 Lift the housing cover onto the housing and loosely tighten the fastening
screws.
2 Secure the housing cover (1) by tightening all 6 screws (2) in a diagonally oppos-
ite sequence [ T_25/
» The device has been mounted and installed.
» Put the device into operation.
5 Configuration and operation
5.1 Signal elements
The 3 LEDs on the device show the different operating states. The LEDs can display the following states:
LED illuminated
Page 10
USB
SD Card
2
5 Nm].
LED flashing
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137 TL3-S
1x RJ 45
7
2x RJ 45
-+ -+
3 4
5 INV OFF - connection for remote controls -
24V(+/- 20%) / 1A (at least 15mA)
6 ERR connection for external grid protection com-
ponent (fault signal relay)
7 Ethernet – only for starting up by means of static
IP (Start-up via cable connection)
RS485
A B
GND
RS485 INV ERR
OFF
- +
A B A B
GND GND
5
1
2
Fig. 10: Closing the housing cover
LED not illuminated
6