Kaco blueplanet gridsave 92.0 TL3-S Guía Rápida página 136

ž In outdoor areas, KACO new energy recommends protecting the device from direct weather exposure and sun-
light. Realisation through constructional measures (e.g. wind catchers) in order to reduce thermal heating of the
components, earlier derating and greater wear of the fans.
Installation surface
ž
Must have adequate load-bearing capacity
ž Must be accessible for installation and maintenance
ž Must be made out of heat-resistant material (up to 194 °F )
ž
Flame-retardant
ž Minimum clearances to be observed during installation: See comprehensive manual under
newen-ergy.com/de/downloads
3.2 Tools used
Shortsign (en) Shape of the connector
External hex
W
Internal hex
A
Torx
T
Slot
S
Tab. 1: Key and description of tool codes
3.3 Fastening the mount
WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only to be used for masonry and concrete.
› Only install the device in an upright hanging position.
4 Installation
4.1 Opening the device
↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 6 screws (2) and carefully remove the housing cover (1) [
2 Be careful not to damage or soil the seals or optical fibers when setting the
housing cover down.
» Proceed with the installation of the device.
4.2 Making the electrical connections
NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic condi-
tions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
Side 136 blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137 TL3-S
Tightening torque
Spanner size or number
Outer contour
Fig. 1: Presentation format
T_25]
Fig. 2: Removing the housing
cover
www.kaco-
in-Ibs
1
2