Greencut GTC300XE Guía De Mantenimiento página 74

TROUBLESHOOTING
PROBLEM-SOLUTION TABLE
THE TABLE INCLUDES SOME OF THE MOST COMMON PROBLEMS AND THEIR REMEDIES.
PROBLEM
• Add fuel to the tank
The engine
• Connect the spark plug wire
doesn't start • The throttle must be placed in the choke position for a cold start.
• Wait for the battery to recharge
Engine runs
irregularly during • Clean or replace air filter
operation
• Drain the old fuel and change it with new one
The engine has a
• Make sure the spark plug wire is properly connected.
hard time starting
• The safety control levers must be in a neutral position to start the engine.
• Raise the cutters to till less depth (using depth regulator)
• Remove and clean the fuel tank
The engine lacks • Clean or change the air filter
power • The carburetor adjustment is incorrect, take the engine to technical service
• Replace the spark plug and adjust the gap
• Drain and recharge the tank and carburetor
The engine does
not stop when the • Check and adjust the throttle
control is in the
"stop" position
The handlebar
moves forward
• The safety control levers must be in the neutral position to start
the engine.
during
The ignition
SOLUTION PROBLEM
Difficult to control
• Put the wheels in tilling position
handlebars when
• Raise the burrs for shallower tillage
tilling
The burrs turn but
• Put the wheels in plowing position
the wheels do not
• If the internal transmission fails, contact your dealer
The teeth turn,
the wheels turn, but
• Lower the teeth to deepen by raising the depth regulator lever
the farmer
It does not move
• Turn off the engine and let it cool
Belts are in neutral • Disconnect the spark plug wire
• Pull down the safety control levers
or reverse position
• Change the belt and spark plug wire
• Adjust the belt tensioner pulleys
• Turn off the engine and let it cool
Straps do not move
• Disconnect the spark plug wire
forward
• Pull down the safety control levers
• Change the belt and spark plug wire
Excess heat builds
• Remove vegetation following instructions
up in the drive/
• FOLLOW ALL SAFETY INSTRUCTIONS
tooth area during
• Check transmission fluid and refill if necessary
trimming
74
EN - GTC300XE
SOLUTION