POWER SUPPLY CONNECTION
CAUTION! (Applies to automatic gas control system)
The connection of the power source should be carried out after all other components of the gas con-
trol system have been connected. Make sure all the elements of the gas control system are tight and
connected so that they can function properly.
Patio heater models equipped with an automatic gas control system with remote control feature a
B6R-R8U receiver that is powered by four 1.5V AA batteries. The remote control is powered with two
1.5 AAA batteries. The need to replace the remote battery is signalled by an indicator in the upper right
corner of the screen, while short beeps appearing within 3 seconds after the firing process is started
mean that the receiver battery needs to be replaced. Used batteries in the receiver may overheat, spill
or even explode. Never use batteries exposed to sun, moisture, high temperatures or vibrations. Only
install batteries of the same type and by the same manufacturer. Never install new batteries with the
used ones.
CAUTION!!!
The heater is designed to work with an 11-kg-LPG cylinder.
The device is sold with complete automation, anti-tilt valve, reducer and connecting cables. Do not
use any other hose or any other system components than the ones installed or indicated by the ma-
nufacturer.
Before replacing the cylinder, make sure the device is not near any fire sources or other sources
that may ignite.
It is essential to close the gas supply valve on the cylinder or the regulator after each use of the
device.
If there is any gas leak, it is absolutely necessary to stop using the device if it is running and
if it is off, do not start it. Then contact the service.
CAUTION!!!
It is recommended to periodically check the quality of all gas connections, including the flexible hose
(at least once a month, or every time when replacing the cylinder). If cracks, damage or other marks
of damage are visible, the components should be replaced with new ones of the same length and
equal quality.
REMOTE CONTROL
The B6R-H9 remote control unit comes with the remote control option.
CAUTION!!!
The B6R-H9 remote control has a built-in temperature sensor used in the thermostat mode. The
unit continuously measures the ambient temperature and compares it to the temperature set
on the thermostat. Keep the device in a dark place to exclude measurement errors related to
the direct sunlight.
PATIO free-standing garden heaters in option with the GV60 module are equipped with a gas control
system allowing the user to remotely fire the device and have full control over it. To be able to operate
the device with the remote control, make sure that the shut-off valve, installed on the gas supply pipe
to the device, is open.
37