Kratki PATIO Manual Del Usuario página 40

Child Proof
Enabling:
To activate the Child Proof function press the
shows the icon.
Disabling:
To deactivate the Child Proof function press the
will disappear.
Manual mode
Lighting the fire in the fireplace with a single button (default setting)
• Press the button until you hear two short beeps. Starting the firing sequ-
ence is confirmed by the occurrence of a flashing icon on the display of the
burner. Release the button.
• Kindling the control flame is confirmed by a single signal.
• After kindling the main burner, the remote control
• automatically switches to the manual mode.
Lighting a fire in the fireplace with two buttons
• Simultaneously press the
short beeps. Starting the firing sequence is confirmed by the occurrence of a
flashing icon on the display of the burner. Release the button.
• Kindling the control flame is confirmed by a single signal.
• After kindling the main burner, the remote control automatically switches to
the manual mode.
Information:
To change the kindling method, immediately after you install the batteries in the
remote control, hold the
a flashing digit corresponding to the current settings.
1 – Lighting a fire by pressing .
2 – Lighting a fire by pressing the
End of the procedure of changing the method of lightening a fire is confirmed with the display
reading the appropriate number.
NOTE!!!
If, after several attempts to fire, ignition of the control flame does not take place, set the main
valve knob to „OFF" and refer to the section „Possible Problems and Solutions".
40
and
button and the
button for 10 seconds. The remote control display shows „ON" and
and the buttons.
buttons. The display
and buttons. The
button until you hear two
icon