Forest-Master FM16D Manual Del Usuario página 15

OPERATING CONDITIONS
This log splitter is a home use model. It is designed for operating under ambient temperatures between
+5°C and 40°C and for installation at altitudes no more than 1000m above M.S.L. The surrounding
humidity should be less than 50% at 40°C. It can be stored or transported under ambient temperatures
between -25°C and 55°C.
ELECTRICAL REQUIREMENTS
Connect the main leads to a standard 230V±10% (50Hz±1Hz) electrical supply which has protection
devices of under-voltage, over-voltage and over-current as well as a residual current device (RCD)
which is maximum residual current rated at 0.03A.
This equipment is fitted with a UK 3 pin mains electricity plug and is supplied with a 2 pin adapter for
use where necessary. DO NOT remove the 3 pin mains electricity plug and fit a 2 pin mains electricity
plug.
If operating the machine with an extension lead, the extension lead must be at least a heavy duty
2.5mm cable. For best performance the lead should be no more than 10 metres long.
2
POSITIONING THE LOG SPLITTER
The log splitter should be positioned level or preferably
positioned with the end where the fixed wedge is,
slightly raised. A difference of 5mm over the length of
the log splitter is sufficient.
It should not be positioned with the fixed wedge end
lower than the operating handle end as this may limit
the flow of oil to the pump.
AIR BLEED SCREW
Before operating the log splitter, the Bleed Screw should be loosened a few
turns until air can flow in and out of the oil tank smoothly. To avoid a log
hitting the bleed screw, ensure the wings are level. Air flow through the Bleed
Screw hole should be detectable during log splitter operation. Before moving
the log splitter, make sure the Bleed Screw is tightened to avoid oil leaking
from this point.
IMPORTANT: failure to loosen the bleed screw will keep air sealed in the hydraulic
system, being compressed and being decompressed. Such continuous air compression
and decompression will blow out the seals of the hydraulic system and cause permanent
damage to the log splitter.
FM16 (Models D & TW)
This end slightly raised
Air Bleed Screw
15