Forest-Master FM16D Manual Del Usuario página 26

16TW STAND ASSEMBLY
1. Before starting assembly, ensure the log
splitter is disconnected from the power supply.
Ensure the bleed screw on the log splitter is
closed.
If you have someone to assist you in turning the
log splitter over then it may be easier to attach
the stand to the log splitter with the splitter
upside down.
Alternatively you can prop the log splitter
vertically against a wall, with the motor end at
the bottom. Then when assembled it can be
lowered to the ground with the wheels acting as
a pivot.
3. Remove the 4 bolts and nuts securing the front foot and
the internal joiner to the front leg mount. Keep the front foot
as this is fitted to the trolley front legs.
26
2. If fitted, remove the rear
wheels. Prise the hub caps off
with a flat bladed screwdriver.
Remove the R-clip from the end
of the axle then remove the axle
and the wheel.
FM16 (Models D & TW)