Forest-Master FM16D Manual Del Usuario página 34

11. Adjust the four leg clamps so that they
are at roughly the same height.
Insert a longitudinal support bar(4) through
a leg clamp on a front leg, insert two battery
clamps (12) over the bar, then insert the
longitudinal bar through the leg clamp on
the rear leg. Adjust the height of the front
and rear leg clamps, so that the longitudinal
bar is level. Tighten the clamp bolts against
the beam to secure it.
Repeat for the
support bar.
The log splitter can now be rotated to the
upright position from the position in which
the stand has been assembled. This may
require two persons.
Adjust the position of the four battery clamps to securely hold you battery then tighten all the
battery clamp bolts.
Brake Pin
34
remaining longitudinal
Thumbscrew
12. To stop the log splitter moving when in use.
Loosen the thumbscrew and slide the brake pin
until it protrudes through one of the holes in the
wheel hub.
This should be done with at least one brake pin
on each axle.
FM16 (Models D & TW)