Publicidad
Idiomas disponibles
Idiomas disponibles
1. Make sure that the power trigger is locked
when the power trigger lockout is in its
initial position.
2. Push the power trigger lockout (A) forward.
Make sure that it moves back to its initial
position when you release it.
3. Make sure that the power trigger and the
power trigger lockout moves freely and that
the return spring works correctly.
4. Start the product. Refer to
product on page 15 .
5. Apply full power.
6. Release the power trigger lockout and
make sure that the cutting attachment
stops fully.
2103 - 004 - 03.11.2023
A
To start the
To do a check of the cutting attachment guard
WARNING:
attachment without an approved
and correctly attached cutting
attachment guard. Always use the
recommended cutting attachment
guard for the cutting attachment
that you use, see
on page 24 . If an incorrect or
faulty cutting attachment guard is
attached this can cause serious
personal injury.
The cutting attachment guard stops objects
that ejects in the direction of the operator. It
also prevents injuries that occur if you touch
the cutting attachment.
1. Stop the motor.
2. Do a visual check for damages, for
example cracks.
3. Replace the cutting attachment guard if it
is damaged.
Battery safety
WARNING:
instructions that follow before you
use the product.
•
Only use an approved Husqvarna
rechargeable battery. Refer to
data on page 23 . The battery is software
encrypted.
•
Use the Husqvarna battery that is
rechargeable as a power supply for
the related Husqvarna products only. To
prevent injury, do not use the battery as a
power supply for other devices.
•
Risk of electrical shock. Do not connect the
battery terminals to keys, coins, screws or
other metal. This can cause a short circuit
of the battery.
•
Do not use non-rechargeable batteries.
•
Do not put objects into the air slots of the
battery.
Do not use a cutting
Accessories
Read the warning
Technical
11
Publicidad
