Husqvarna 330iKL Manual Del Usuario página 19

To replace the trimmer line
1. Hold the lower half (A) of the trimmer head
with one hand. Turn the top half (B) of the
trimmer head clockwise with your opposite
hand.
A
Note:
When you turn the top half of the
trimmer head, you will hear a click.
2. Continue to turn the top half of the trimmer
head until the triangle (C) aligns with the
hole (D).
3. Pull out and discard the remaining trimmer
line.
4. Cut approximately 22 ft (6.7 m) of new
trimmer line.
5. Put 1 end of the trimmer line into 1 of the
holes.
2103 - 004 - 03.11.2023
6. Push the trimmer line through the trimmer
B
C
7. Pull the trimmer line through the trimmer
D
8. Hold the lower half of the trimmer head
9. Continue to turn the top half of the trimmer
head and through the opposite hole.
head until there is an equal length of
trimmer line on each side.
stable with one hand. Turn the top half
of the trimmer head clockwise with your
opposite hand.
head until approximately 5 in. (127 mm)
of the trimmer line is extended from each
hole.
E
Note:
If the trimmer line is too long on
one side of the trimmer head, cut the
trimmer line to the correct length.
19