Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
If you release the power trigger, the
product sets to the last speed mode when
you start it again. If the product automatically
stops, the product sets to normal mode when
you start it again.
To select a speed mode
You can set necessary speed mode when you
operate the product.
•
Push the speed mode button until the
correct speed mode is selected. The LEDs
come on, refer to
page 16 .
Automatic shutdown function
The product has an automatic shutdown
function that stops the product if the product
is not used. The green LED for start/stop
Introduction
WARNING:
understand the safety chapter
before you do maintenance on the
product.
Maintenance
Clean the external parts of the product with a dry cloth. Do not
use water.
Examine that the power button works correctly and is not dam-
aged.
Make sure that the power trigger and the power trigger lockout
function correctly from a safety point of view.
2103 - 004 - 03.11.2023
Speed mode function on
Maintenance
Read and
indication goes off and the product stops after
120 seconds.
To stop the product
1. Release the power trigger or the power
trigger lockout.
2. Push the power button.
3. Push the release buttons on the battery
and pull the battery out.
Maintenance schedule
WARNING:
before you do maintenance.
The following is a list of the maintenance
steps that you must do on the product. See
Introduction on page 17 for more information.
Daily
Remove the battery
Month-
Weekly
ly
X
X
X
17
Publicidad
