Fein GRIT GX752V Manual Del Usuario página 15

Daily maintenance
Blow out the ventilation slots (16) at the motor
housing and the marked locations with compressed
air (see Instruction label (25)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (25)).
Check the drive disc (21) and the contact disc (19) for
wear and damage each time when replacing a grinding
belt. Have damaged parts replaced.
Loosen star-knob bolt (12).
Remove the chip/grinding-dust box (11) and dispose of
the metal dust.
Before emptying, the contents of the chip/grinding-dust
box must have cooled down sufficiently and may only be
disposed of in suitable containers.
Mount the emptied chip/grinding-dust box again and set
the gap clearance of the grinding rest. (figure 4)
Tighten star-knob bolt (12).
Cleaning the exterior of the machine with compressed
air.
If required, you can change the following parts yourself:
Grinding belt, spark guard (9)
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your machine may include only a
part of the accessories described or shown in this instruc-
tion manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH,
C-D1_IA, D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out machines and accessories should be
sorted for environment-friendly recycling.
Connection diagrams.
Type GX75
Type GX752V
Type GX752H
Type GX752H2V
en
Page 99
Page 100
Page 101
Page 102
15