cosori CMC-CO601-SEU Manual Del Usuario página 17

Test Run
Make sure you perform a Test Run before
using your pressure cooker. This will help
you learn how to use the cooker, and make
sure it's working properly.
1. Make sure the inner pot is clean and
empty.
2. Add 750 mL / 3 cups of water to the
inner pot. [Figure 3.1]
x3
3. Place the lid on the pressure cooker and
turn clockwise to secure. The pressure
cooker will make a sound to indicate the
lid is locked. [Figure 3.2]
4. Select PRESSURE COOK and press the
– or + buttons to set the cook time for 5
minutes. [Figure 3.3]
CAKE
5. Press PRESSURE to select HIGH pressure.
6. Press KEEP WARM to turn off automatic
KEEP WARM.
Note: KEEP WARM is on by default.
Figure 3.1
Figure 3.2
Figure 3.3
7. Press START to begin cooking. The
pressure cooker will beep once, then
start pre-heating. The progress bar will
light up under 'PREHEATING' and the
display will show
8. Once done preheating, the progress bar
will light up under 'COOKING' and the
timer countdown will begin.
9. When the test run ends, the display will
show 'END' and the pressure cooker
will beep 10 times to indicate cooking is
finished.
10. The pressure cooker will begin to
naturally release the pressure. Once the
pressure has been completely released,
the float valve will drop.
• Optionally, you can quick release or
timed natural release the pressure
before opening the lid. See Releasing
Pressure (page 14).
• The lid will unlock when the float
valve drops down.
11. Twist the lid anticlockwise. The pressure
cooker will make a sound to indicate the
lid is unlocked. Lift to remove.
[Figure 3.4]
Figure 3.4
12. Use oven mitts to carefully remove the
inner pot. Discard the water.
13. Allow the inner pot to cool, then dry
using a soft towel.
Note: All pressure cookers may have a plastic smell
from the manufacturing process. This is normal. If
the plastic smell does not decrease after a test run,
contact Customer Support (see page 32).
EN
.
17