Beurer EM 49 Instrucciones De Uso página 26

7. USE
Notes on use
• The device switches itself off automatically if it is not used for one
minute (automatic switch-off). When the unit is switched on again,
the LCD screen displays the menu selection and the most recently
used menu flashes.
• A brief acoustic signal is output when a valid button is pressed. Two
brief acoustic signals are output when an invalid button is pressed.
• You can pause the stimulation at any time by briefly pressing the ON/
OFF button . To continue the stimulation, briefly press the ON/OFF
button again and set the desired impulse intensity again.
Starting application
Step 1: Look for a suitable program from the program tables (see section
„6. Program overview").
Step 2: Place the electrodes on the desired area for treatment (for positi-
oning suggestions see section „6.4 Information regarding the positioning
of electrodes") and connect them to the device.
Step 3: Press the ON/OFF button
Step 4: Press the MENU button to navigate through the
/ menus and press the ENTER button to confirm
your selection.
Step 5: Use the / setting buttons to select the program number you
want and press the ENTER button to confirm your selection. At the start
of the stimulation treatment, the impulse intensity of
to 00 by default. No impulses are sent to the electrodes yet.
Step 6: Use the left and right / setting buttons for
select the impulse intensity you want. The indicator for impulse intensity
in the display changes accordingly. If the program is in a pause phase, the
intensity cannot be increased.
to switch on the device.
and
and
General information
If you wish to return to the previous selection menu, press the MENU
button. By holding down the ENTER button, you can skip individual
setting steps and start directly with the stimulation treatment.
Keylock
Locks the buttons to avoid them being pressed
unintentionally.
1. To activate the keylock, hold down the
is visible in the display (approx. 3 seconds).
2. To deactivate the keylock, hold down the
disappears from the display (approx. 3 seconds).
Pausing application
You can pause the stimulation at any time by briefly pressing the ON/
OFF button . To continue the stimulation, briefly press the ON/OFF
button again and set the desired impulse intensity again.
8. PROGRAM OVERVIEW
The digital EMS/TENS unit features a total of over 70 programs:
• 15 TENS programs
/
• 35 EMS programs
• 20 MASSAGE programs
In all programs you can set the impulse intensity of both channels indi-
vidually.
You can also set various parameters in the TENS programs 13 – 15 and
is set
the EMS programs 33 – 35 to adjust the stimulating effect to the applica-
tion area.
to
26
button until the symbol
button until the symbol