Beurer EM 49 Instrucciones De Uso página 31

2. Select the TENS 13 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the impulse frequency you want
and use the ENTER button to confirm.
4. Use the / setting buttons to select the impulse width you want and
use the ENTER button to confirm.
5. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
6. Use the left and right / setting buttons for
the impulse intensity you want.
TENS 14 program
The TENS 14 program is a burst program that you can also customise.
Various impulse sequences run in this program. Burst programs are suita-
ble for all areas of application to be treated with changing signal patterns
(to minimise the level of accustoming to the treatment). In this program
you can set an impulse width of between 80 and 250 µs.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section 6.4) and connect them
to the device.
2. Select the TENS 14 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the impulse width you want and
use the ENTER button to confirm.
4. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
5. Use the left and righ / setting buttons for
the impulse intensity you want.
TENS 15 program
TENS 15 is a program that you can also customise. In this program, you
can set the impulse frequency to between 1 and 150 Hz. The impulse
width changes automatically during the stimulation treatment.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section 6.4) and connect them
to the device.
2. Select the TENS 15 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the impulse frequency you want
and use the ENTER button to confirm.
4. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
and to select
5. Use the left and right / setting buttons for
the impulse intensity you want.
EMS 33 program
EMS 33 is a program that you can also customise. In this program, you
can set the impulse frequency to between 1 and 150 Hz and the impulse
width to between 80 and 320 µs.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section 6.4) and connect them
to the device.
2. Select the EMS 33 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the impulse frequency you want
and use the ENTER button to confirm.
4. Use the / setting buttons to select the impulse width you want and
use the ENTER button to confirm.
5. Use the / setting buttons to select the treatment time you want and
and to select use the ENTER button to confirm.
6. Use the left and right / setting buttons for
the impulse intensity you want.
EMS 34 program
EMS 34 is a program that you can also customise. In this program, you
can set the impulse frequency to between 1 and 150 Hz and the impulse
width to between 80 and 450 μs. You can also set the working time and
pause time for this program to between 1 and 30 seconds each.
31
and to select
and to select