Beurer EM 49 Instrucciones De Uso página 34

12. CLEANING AND STORAGE
Adhesive electrodes
• To ensure that the adhesive electrodes remain adhesive for as long
as possible, clean them carefully with a damp, lint-free cloth or clean
the underside of the electrodes under lukewarm, running water and
pat dry with a lint-free cloth.
Before cleaning with water, remove the connection cables from
the electrodes.
• Reapply the electrodes to the carrier foil following treatment.
Cleaning the device
• Remove the batteries from the device before cleaning.
• Clean the device after use with a soft, slightly damp cloth. If it is very
dirty, you can also moisten the cloth with a mild soapy solution.
• Do not use any chemical or abrasive cleaning agents.
Ensure that no water enters the device.
Reuse of the device
Once it has been properly prepared, the device can be used again. Prepa-
ration includes replacement of the treatment electrodes as well as clean-
ing of the surface of the device using a cloth moistened with a mild soapy
solution.
Storage
• Remove the batteries from the device if you will not be using it for a
prolonged period of time. Leaking batteries may damage the device.
• Do not make sharp bends in the connection cables and electrodes.
• Disconnect the connection cables from the electrodes.
• Reapply the electrodes to the carrier foil after use.
• Store the device and accessories in a cool, well-ventilated space.
• Never place any heavy objects on the device.
13. DISPOSAL
The empty, completely flat batteries should be disposed of through spe-
cially designated collection boxes, recycling points or
electronics retailers. You are legally required to dispose
of the batteries.
Note: The codes below are printed on
batteries containing harmful substances: Pb = Battery
contains lead, Cd = Battery contains cadmium, Hg = Battery
contains mercury.
For environmental reasons, do not dispose of the device in the
household waste at the end of its useful life. Dispose of the unit
at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electri-
cal and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.
14. PROBLEMS/SOLUTIONS
The device does not switch when the ON/OFF button
How to proceed:
(1) Ensure batteries have been inserted correctly and are in contact with
the terminals.
(2) Replace batteries, if applicable.
(3) Contact Customer Services.
Electrodes do not adhere to the body. How to proceed:
(1) Clean the adhesive surface of the electrodes using a damp, lint-free
cloth. Replace the electrodes if they still do not adhere securely.
(2) Clean the skin prior to any application; do not use skincare lotions or
oils prior to treatment. Shaving may increase the life of electrodes.
There is no noticeable stimulation. How to proceed:
(1) Press the ON/OFF button
nection cables are correctly connected to the electrodes. Ensure the
electrodes are in firm contact with the treatment area.
(2) Ensure the connection plug is firmly connected to the device.
(3) Press the ON/OFF button
34
is pressed.
to interrupt the program. Check the con-
to restart the program.