Beurer EM 49 Instrucciones De Uso página 32

1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section 6.4) and connect them
to the device.
2. Select the EMS 34 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the working time ("on time") you
want and use the ENTER button to confirm.
4. Use the / setting buttons to select the pause time ("off time") you
want and use the ENTER button to confirm.
5. Use the / setting buttons to select the impulse frequency you want
and use the ENTER button to confirm.
6. Use the / setting buttons to select the impulse width you want and
use the ENTER button to confirm.
7. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
8. Use the left and right / setting buttons for
the impulse intensity you want.
EMS 35 program
EMS 35 is a burst program that you can also customise. Various impulse
sequences run in this program. Burst programs are suitable for all areas
of application to be treated with changing signal patterns (to minimise
the level of accustoming to the treatment). In this program, you can set
the impulse frequency to between 1 and 150 Hz and the impulse width to
between 80 and 450 μs. You can also set the working time and pause time
for this program to between 1 and 30 seconds each.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section 6.4) and connect them
to the device.
2. Select the EMS 35 program as described in section "5.2 Starting ap-
plication" (step 3 to step 5).
3. Use the / setting buttons to select the working time ("on time") you
want and use the ENTER button to confirm.
4. Use the / setting buttons to select the pause time ("off time") you
want and use the ENTER button to confirm.
5. Use the / setting buttons to select the impulse frequency you want
and use the ENTER button to confirm.
6. Use the / setting buttons to select the impulse width you want and
use the ENTER button to confirm.
7. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
8. Use the left and right / setting buttons for
the impulse intensity you want.
10. DOCTOR'S FUNCTION
The Doctor's function is a special setting to allow you to access your
personal program even more easily and directly.
Your individual program settings are instantly recalled and activated when
the device is switched on.
You may wish to adjust this individual program following advice from your
doctor.
and to select
Setting the Doctor's function
• Select your program and the corresponding settings as described in
section "5.2 Starting application".
• At the start of the stimulation treatment, the impulse intensity of
electrodes yet. Before setting the desired impulse intensity using the
intensity setting buttons, press and hold the
seconds. Storage in the Doctor's function is confirmed with a long
acoustic signal. If you switch on the device again, the program you
saved using the Doctor's function is automatically opened directly.
Deleting the Doctor's function
To clear the device again and to re-allow access to other programs, press
and hold the
impulse intensity of
tor's function is confirmed with a long acoustic signal.
32
and is set to 00 by default. No impulses are sent to the
-button again for approx. 5 seconds. To do this, the
and must be set to 00. Deletion of the Doc-
and to select
-button for 5