Kärcher IVR-L 100/24-2 Manual Del Usuario página 15

Drum pump on/off switch
10
Drum pump flow rate adjustment (turn
11
switch)
Drum pump
12
Drum pump disposal hose
13
Suction hose connection
14
Power switch
15
Suction head lock
16
Mains cable
17
Disposal hose holder
18
Unlocking lever
19
Stand pipe for drum pump
20
Tilting chassis
21
Accessory holder
22
Start-up
See graphics page for illustrations
1. Bring the device into the working posi-
tion.
2. If necessary, secure the device using the
parking brake.
3. Ensure that the suction head is fitted
correctly.
4. Insert the suction hose into the suction
hose connection.
Illustration B
5. Plug the desired accessory onto the suc-
tion hose.
Operation
For the figures, please refer to the graphics
pages
1. Plug the mains plug into the socket.
2. Switch on the device at the trigger.
Illustration C
The switch has multiple level settings:
0 The device is off.
1 Motor 1 is switched on.
2 Motors 1 and 2 are switched on.
3. Start vacuuming.
Suction process
Note
Only immerse the accessory halfway when
vacuuming liquids to encourage sufficient
air.
Checking the filling level display
See graphics pages for illustration
Illustration D
Note
The red marking on the drain hose shows
the maximum permissible filling level.
ATTENTION
Risk of damage to the device
The liquid container will overflow within a
few seconds of filling.
Constantly check the filling level in the liq-
uid container when filling large quantities of
liquid.
Emptying the liquid container
For the figures, please refer to the graphics
pages
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Empty the liquid container:
a Connect the drain hose to the upper
hose coupling.
Illustration E
b Hold the drain hose over a suitable
collecting container and drain the con-
tents.
4. Dispose of or reuse the contents in ac-
cordance with statutory regulations.
Emptying the liquid container by
See graphics page for illustrations
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Take the drum pump out of the stand
pipe.
Illustration F
4. Remove the suction head, (see chapter
Removing the suction head).
5. Remove all accessory parts.
6. Prepare the liquid container for empty-
ing:
English
tilting
15