Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Please read and comply with this
instruction manual prior to first use of
your device.
Keep these operating instructions for
later use or for a subsequent owner.
Note
Modification of the device or manu-
facturing of additional devices is not
permitted. Such modifications can result
in personal injury or malfunctions.
▸
Only appointed and trained personnel may carry
out repairs to the device. For such purposes,
always use original spare parts from Adolf Würth
GmbH & Co. KG. This will ensure the continuing
safe operation of the device.
Signs and symbols
The signs and symbols in these instructions should
help you to use the instructions and the machine
quickly and safely.
Note
Provides information on the most effec-
tive or most practical use of the tool.
▸
Handling step
The defined sequence facilitates correct and safe
use of the device.
Result
3
The result of a sequence of handling steps is
described here.
[1] Item number
Item numbers are indicated in the text with
square brackets [].
For Your Safety
Failure to observe these operating instructions and
the safety instructions may result in damage to the
device and dangers for the operator and other
persons.
In case of transport damage, inform your dealer
immediately.
Safety instructions
General
▸
Never ignore the safety instructions.
▸
When using the tool, bear in mind that the fas-
teners could be deflected and thus cause injuries.
▸
Keep your fingers away from the trigger if you
are not actually operating the tool and merely
swapping the tool from one working position to
another.
▸
Keep all body parts such as hands and legs, etc.
away from the direction of shooting and ensure
that the fastener cannot penetrate through the
workpiece into a body part.
▸
Ensure that you have read and understood the
safety instructions before connecting, discon-
necting, loading, operating or servicing the tool,
or changing accessories or working in the vicinity
of the tool. Failure to comply could result in
severe injuries.
▸
During operation, place the nail outlet opening
of the tool correctly on the working surface. If
the outlet opening is not correctly positioned,
the fasteners could be ejected away from the
working surface.
▸
Hold the tool firmly in the hand and be prepared
for the recoil.
▸
Only technically accomplished operators should
use the tool.
▸
Do not make any changes to the tool. Modifica-
tions can reduce the effectiveness of the safety
precautions and increase the risk for the operator
or bystanders.
▸
When operating with a tool, which is intended
for use on hard surfaces such as steel or
concrete, additional contact pressure must be
applied to operate the tool and prevent slipping.
WARNING − Prior to first use always
read the Safety instructions!
23
Publicidad
