Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
7. Pull out needle spring and the paint needle. Place
it in the secondary container to soak.
8. Using wrench (L), unscrew the Fluid Nozzle by
turning counterclockwise and place it in the
secondary container to soak.
9. After 3-5 minutes, remove each item and use a clean dry towel to wipe off the entire item and
inspect it for any remaining paint or dirt to wipe remains.
IMPORTANT:
To ensure all residue of material is removed from the part, use a blow gun with an
approved OSHA gun tip to blow any excess cleaning solution off the part that a rag
cannot get to.
If paint or dirt debris is still present, use a non-wire soft bristle brush and brush the
area.
NOTE:
Soaking of parts may require longer to get all paint residue off the part.
RE-ASSEMBLING SPRAY GUN
1. Screw the Fluid Nozzle into the face of the spray
gun by turning it clockwise, using the wrench (L)
(13 mm) to tighten securely.
NOTE: DO NOT OVERTIGHTEN.
7
8
L
Fluid
nozzle
1
L
Fluid
nozzle
14
Publicidad
