Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare
parts with package contents list. If any part is missing or damaged, do not attempt to assemble
the product.
Estimated Assembly Time: 1 - 3 minutes.
Tools Required for Assembly (not included):
• 5/8 in. (16 mm) wrench
• Thread Sealant Tape
• Female Plug
SPRAY GUN SET-UP
WARNING:
TO PREVENT SERIOUS INJURY FROM EXPLOSION:
Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon
dioxide, combustible gases, or any other bottled gas as a power source for this tool. Lubricators
should not be used with spray guns. The use of inline lubricators will contaminate the material
and will ruin the paint finish.
Siphon Feed
Method of material feed where atmospheric pressure creates a partial vacuum to siphon material
to the gun. Only external mix air caps are used with this method. Siphon feed is used with light
bodied latex paints.
Air Supply Set-up
1. Not all accessories shown are included, but are recommended for best performance
(See Figure 1).
2. It is recommended that an in-line air filter be incorporated into the air supply.
1
L
1
Recommended Air Line Set-Up
PART NO.
Description
1
Siphon Feed Spray Gun
L
Air Pressure Regulator (not included)
Female Plug (not included)
3
4
Female Coupler (not included)
5
Air Hose (not included)
6
In-Line Filter (not included)
Air Compressor (not included)
7
3
4
5
3
8
4
6
6
7
Publicidad
