Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Tighten female plug (not included), turning
clockwise with a wrench (not included) for
air tight connection (See Figure 1).
DO NOT OVERTIGHTEN.
NOTE: Use threaded sealant tape (not included) on
the threading of the male plug on the bottom of the
spray gun.
NOTE:
As an option, you can connect an Air Pressure
Regulator to the bottom of the spray gun and then
attach the female plug to the bottom of the air
pressure regulator.
2. Depending on which spray gun you are using, set
the air compressor to the specified pressure. Attach
air line coming from compressor to the spray gun.
NOTE: If you use the air pressure regulator, adjust the
air pressure so the gauge on the regulator reads the
recommended pressure when the trigger is pulled.
OPERATING INSTRUCTIONS
The paint sprayer will not properly spray unless the fan direction is either set vertically or
horizontal.
Before using desired paint in the spray gun, spray a compatible thinner or solvent through the
gun to remove any containments and residue.
Before adding paint, make sure all thinner or solvents are removed from the spray canister.
It is recommended that you pour the material through a filter into a smaller container prior to
filling the paint cup.
Set up a piece of cardboard or other scrap material to use as a target to test spray. Continue
to test spray until the desired spray pattern is achieved.
1
2
WARNING
NOTE
9
I
Publicidad
