Stiga SRSW01 Manual De Instrucciones página 13

3.5. CUTTING HEIGHT ADJUSTMENT
PLATFORM TYPE SRSW01 - MANUAL ADJUSTMENT
1. Switch off the robot lawn mower in safety conditions
(see par. 1.4).
2. Use the height adjuster (Fig. 12.P) to select the desired
cutting height so that the patch of grass being cut is not
higher than 10 mm.
NOTE: The length of the grass cut by the robot lawn
mower must not exceed 10 mm.
PLATFORM TYPE SRBW01 - ELECTRICALLY ADJUSTABLE
Follow APP wizard to adjust the cutting height.
The blade height adjustment system requires an initial
calibration and subsequent periodic calibrations, which are
performed automatically. Calibration can also be performed
manually using the dedicated menu in the App.
CAUTION:
Do not touch the cutting means when adjusting
the cutting height.
NOTE: The length of the grass cut by the robot lawn
mower must not exceed 10 mm.
4. MAINTENANCE
CAUTION:
Only use original spare parts.
CAUTION:
Do not modify, tamper with, elude or eliminate
the safety devices installed.
CAUTION:
Danger of cutting hands.
Use protective gloves to avoid cutting your
hands.
CAUTION:
Danger of dust in the eyes.
Use safety glasses to avoid the danger of
dust in the eyes.
WARNING:
Too much water can filter in and damage
electrical parts.
BAN:
Do not use pressurized water jets.
BAN:
To avoid irreversible damage to the electrical
and electronic components, do not immerse
the robot lawn mower, partially or completely,
in water.
BAN:
Do not wash the internal parts of the robot
lawn mower to avoid damaging the electrical
and electronic components.
EN
BAN:
Do not use solvents or petrol so as not to
damage varnished surfaces and plastic parts.
4.1. SCHEDULED MAINTENANCE
For a better operation and longer life, be sure to clean the
product regularly and replace worn parts.
Perform the interventions following the frequency indicated
in the table.
FREQUENCY
Weekly
Monthly
At the end of the
mowing season or
every six months
if the robot lawn
mower is not used
Annual or at the
end of the cutting
season
It is necessary to carry out a maintenance servicing annually
at an authorized service centre to keep the robot lawn mower
in good working conditions.
NOTE: any malfunction due to not having carried out the
annual servicing will not be recognized under warranty.
4.2. REPLACEMENT OF THE CUTTING BLADES
1. Switch off the robot lawn mower in safety conditions
(see par. 1.4).
2. Turn the robot lawn mower upside down, taking care not
to damage the floating cover.
3. Unscrew the fixing screws (Fig. 14.E).
4. Replace the cutting blades (Fig. 14.D).
5. Tighten the fixing screws (Fig. 14.E).
4.3. WINTER BATTERY MAINTENANCE AND
STORAGE
1. Charge the battery according to the guided procedure in
the App, accessible from the "Settings" page.
2. Clean the robot lawn mower (see the the Complete
Instruction Manual).
3. Check the robot lawn mower is switched off and store in
a dry place, protected from icy conditions.
6
COMPONENT TYPE OF
INTERVENTION
Blade Clean and check blade
efficiency (See Par. 4.2)
If the blade is bent due
to impact or if it's worn,
replace it. (See Par. 4.2)
Recharging Clean and eliminate any
contacts oxidising. (See the com-
plete instruction Manual)
Robot lawn Carry out cleaning. (See
mower the complete instruction
Manual)
Charging base Check for wear or deterio-
and power ration and replace if nec-
cables essary. (See the complete
instruction Manual)
Battery Perform the pre-storage
charging of the battery.
(See Par. 4.3)
Robot lawn Carry out the servicing
mower at an authorized service
centre. (See Par. 4.1)