Stiga SRSW01 Manual De Instrucciones página 14

NOTE: For more detailed information on the winter
charging procedure, please refer to the Complete
Instruction Manual.
NOTE: Registering the charge through the app procedure
is required for the battery warranty to be valid.
4.4. BATTERY REPLACEMENT
Battery replacement is the sole responsibility of the STIGA
TECHNICAL ASSISTANCE STAFF.
If the battery needs to be replaced, contact a service centre
or your retailer.
TRANSPORT, STORAGE AND
5.
DISPOSAL
5.1. TRANSPORT
NOTE: We recommend using the original packaging for
transport over long distances.
1. Switch off the robot lawn mower in safety conditions
(see Par. 1.4).
2. Clean the robot lawn mower (see the the Complete
Instruction Manual).
3. Lift the robot lawn mower by its handle (Fig. 15.D) and
carry it, making sure to keep the cutting blade away from
the body.
6. TROUBLESHOOTING
CAUTION:
Stop the robot lawn mower and bring it back to safety conditions (See Par. 1.4).
Below there is the list of any anomalies that may arise during the work phase.
PROBLEM
Abnormal vibrations. The robot lawn
mower is noisy.
The robot lawn mower does not
position itself properly inside the
charging station.
The mower robot behaves abnormally
around perimeter obstacles.
The charging base light does not
turn on when the robot is out of the
charging base.
The charging base light turns on slowly
The charging base light turns on with
quick flashing
The warning icon is on on the keyboard It indicates anomaly / failure conditions.
CAUSES
Damaged cutting disc or blades
Cutting device blocked by residues (tapes, ropes,
plastic fragments, etc.).
The robot lawn mower was started in the presence
of unexpected obstacles (fallen branches, forgotten
objects, etc.).
Electric motor failure
Grass too tall
Incorrect position of the perimeter cable.
Land subsidence in the vicinity of the charging base. Restore the correct positioning of the charging base. (See
Perimeter cable laid in the wrong way
The supply voltage is missing or there is a fault in
the charging base.
The perimeter cable is not connected or is broken Check the installation and repair the break (See Par. 2.3)
the perimeter cable is too short or there is a fault in
the charging base.
EN
5.2. STORAGE
The robot lawn mower must be stored horizontally in a dry and
frost-free place after cleaning and charging the battery in the
winter (see Chap. 4). During long periods of inactivity, disconnect
the charging base from the mains.
5.3. DISPOSAL
CAUTION:
To remove the battery from the robot lawn
mower, contact an authorized service centre.
1. Dispose of the product packaging in a sustainable way in
the appropriate collection containers or at special centres
authorized for collection.
2. Dispose of the robot lawn mower in accordance with local
legal requirements.
3. Contact appropriate facilities for recycling and disposal as
the robot lawn mower is classified as WEEE (Waste Electrical
and Electronic Equipment).
4. Dispose of old or used batteries in a sustainable way in
collection containers or at authorized collection centres.
SOLUTIONS
Replace the damaged components (See Par. 4.2).
Switch off the robot lawn mower in safety conditions (See
Par. 1.4). Unlock the cutting blade.
Switch off the robot lawn mower in safety conditions (See
Par. 1.4). Remove the obstacles and restart the robot lawn
mower.
Replace the motor, contact the nearest authorized service
centre.
Increase the cutting height (See Par. 3.5).
First mow the area with a normal lawnmower
Check the connection of the charging station (See Par. 2.3.2).
Par. 2.3.2).
Reposition the perimeter cable correctly (clockwise) (See
Par. 2.3.1).
Check that the power supply unit is plugged in correctly. Check
the integrity of the power supply connection cable.
Check that the length of the perimeter cable is greater than
indicated in Par. 2.3.2. If the problem persists, contact a
service centre.
For more info consult the app or refer to the Complete
Instruction Manual.
7