Parkside PBK 4 B3 Traduccion Del Manual De Instrucciones Originales página 54

GB MT
1. Hold the cutter bar by the handle (14)
to adjust the cutter bar.
2. Unlock the safety lever (61) and keep it
pressed.
3. By pressing the locking lever (60) at the
same time, you release the fixation of
the cutter bar.
4. Now you can swing out the cutter bar.
Use the ratchet steps and allow the
locking lever (60) to click back into
place.
The device has 12 possible
working positions.
5. Then, release the safety lever (61)
again and ensure that it latches back
into its initial position.
Putting the shoulder
strap on
The body protection (31) on
the shoulder strap must be
placed between the body and the
device.
Generally, we recommend using the
shoulder strap whenever using the
device.
Always turn the device off
before taking off the shoul-
der strap. Accident hazard!
ous situation.
In a hazardous situation, press on
either side of the quick release de-
54
The shoulder strap
is equipped with a
quick release de-
vice so that the
device can be re-
leased quickly
from the shoulder
strap in a danger-
vice (see
release device.
1. Wear the shoulder strap (29) like a
backpack. The clip must be situated on
the chest.
2. Adjust the strap length so that the body
protection (31) is level with the hip.
Place the body protection (31)
on your hip between your body
and the device.
3. Open the quick-release lock (30).
4. Push on the snap hook and attach the
snap hook to the carrying eye (6) on
the tubular shaft (5) of the device.
5. Clip the quick release lock (30) togeth-
er with the device back onto the shoul-
der strap (29).
When wearing the shoulder strap
(29), make sure you place the pads
on your shoulders for greater comfort.
Sliding the carrying eye
Select the appropriate position for the car-
rying eye (6) for spool/3-tooth blade and
pruner/hedge trimmer respectively.
You can slide the carrying eye (6) to better
distribute the weight of the device.
For spool/3-tooth blade operation:
Without touching it by hand, the device
attached to the shoulder strap should be as
follows,

allow the spool to rest lightly on the
ground.

The 3-tooth blade should be balanced
around 20 cm above the ground.
1. Loosen the screw (62) on the carrying
eye for the shoulder strap using the hex
key (28) and tighten it only slightly.
) to clear the quick