Parkside PBK 4 B3 Traduccion Del Manual De Instrucciones Originales página 55

2. Depending on the cutting tool, balance
the device according to the above cri-
teria by moving the carrying eye (6) on
the tubular shaft (5).
3. Tighten the screw (62) when the device
is in the desired position.
Extending the line
A
Your device is equipped with a dual line
auto-tap feature, i.e. the two strings are
extended when you tap the cutting head
on the ground.
1. Hold the device in operation over a
grassy area.
2. Tap the cutting head lightly on the
ground a few times. This causes the
line to lengthen.
The line cutter (19) inserted in
the extension (18) of the protec-
tive cover cuts the line to the desired
length.
If the line ends cannot be length-
ened:
• Turn off the device.
• Press the spool insert as far as it will go
and pull firmly on the end of the string.
If no line ends are visible:
• Replace the spool (see chapter on 'Re-
placing the spool').
Caution! Thread remnants
can be projected and lead to
injuries.
Switching on and off
Start the engine at least 3
meters from where you refu-
elled.
The saw chain must not move when
idle. If the saw chain moves when
the engine is idle, there is a problem with
the clutch or no-load rotation speed. Please
contact the service centre.
The device is automatically
speed-controlled. When idling with-
out load, the engine speed is lower.
1. When using the spool:
Make sure that the protective cap on
the line cutter (
When using the 3-/4-tooth
blade:
Make sure that the extension (
the protective cover extension (
is removed.
2. Place the device on a firm level sur-
face. Make sure that the cutting tool
does not touch either other objects or
the ground.
Cold start:
3. Set the choke lever (64) in position
.
4. Press the fuel pump (primer) (65) 6
times.
5. Hold the device with one hand on the
handle (8). With the other hand, pull
on the starter handle (63) of the starter
cable quickly several times in succes-
sion until the engine starts.
Caution! Do not pull the starter ca-
ble out too far - Danger of break-
age!
If the device does not start after 3-4
attempts, set the choke manually to
position
6. Press the throttle lock (36) and then the
throttle lever (7) briefly to enable the
GB
18) is removed.
A
A
A
.
MT
19) of
21)
55