Parkside PBK 4 B3 Traduccion Del Manual De Instrucciones Originales página 62

GB MT
5. Place the new spool (69) into the spool
cap cover (17) and insert the two ends
of the line through the line outlet loop
(66). Loosen the two line ends from the
grooves (70) on the spool.
6. Place the spool (69) inside the lid of
the spool cap (17) and reassemble the
lid and base.
Ensure that the line outlet loops
(66) match the two recesses (67)
in the spool cap otherwise the cover
will not close.
Illustration
7. Screw the spool cap (17) anticlockwise
back onto the uptake spindle (50).
8. Remove the hex key (28)!
9. Trim the line cord to approx. 15 cm.
Winding up the spool
As an alternative to a new spool, you can
purchase a 2.4 mm-thick, 6 m-long nylon
line in specialist shops and wind this your-
self onto the spool.
A spare line is already included in
the delivery.
1. Fold the line in the middle and place
the middle of the line in the notch (71)
of the spool (69).
Wind up the two ends in the
direction of the arrow, which
is shown on the topside of
the spool.
2. Then clamp the end of each line in one
of the grooves (70) on the spool (69).
Replacing/adjusting the
spark plug
Worn spark plugs, or a spark plug
gap that is too large, will lead to a
reduction in engine power.
62
:
1. Switch the engine off.
2. Pull the spark plug connector (73) off
the spark plug (72).
3. Unscrew the spark plug (72) anticlock-
wise with the enclosed maintenance
key (26).
4. Check the spark plug gap with the
help of a feeler gauge (available from
specialised dealers). The electrode air
gap must be 0.6-0.7 mm.
5. Reset the gap if necessary, by carefully
bending the ground/side electrode of
the spark plug (72).
6. Clean the spark plug (72) with a wire
brush.
7. Reinsert the cleaned and adjusted
spark plug (72) or replace damaged
spark plugs (72) with a new spark plug
(e.g. spark plug "TORCH L8RTC").
8. Reattach the spark plug connector (73).
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section.
Sharpening the line cutter
Never use the device without
a string cutter or defective line
cutter. There is a risk of injury. If the
line cutter blade is damaged, be
sure to contact our service centre.
Wear protective gloves in order to
avoid cutting yourself.
1. Unscrew the line cutter (18) from the
extension (19) of the protective cover
(21).
2. Clamp the line cutter (18) in a vice and
sharpen the knife with a fl at fi le. File
carefully, and always in one direction
only.