INSTRUCTION FOR USE
OPERATING GUIDE
WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER!
– WARNING!
– CAUTION!
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do not cover these
plates for any reason and immediately replace them if damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly in-
stalled or connected. The batteries must be installed by qualified personnel only. Set the function of the elec-
tronic board and the built-in battery charger according to the type of batteries used (WET or GEL/AGM
batteries). Check the batteries for damage before installation. Disconnect the battery connector and the battery
charger plug. Handle the batteries with great care. Install the battery terminal protection caps supplied with
the machine.
NOTE
The machine requires two 12 V batteries, connected according to the diagram (Figure 3).
A
B
Figure 3
11
ENGLISH