Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION FOR USE
The machine can be supplied in one of the following modes:
A) Batteries (WET or GEL/ AGM) already installed and charged
1.
Check that the batteries are connected to the machine with the connector (B, Figure 3).
2.
Pressing the switch (39 Figure 2). If the green warning light (33) turns on, the batteries are fully charged. If the yellow (32) or red
warning light (31) turns on, the batteries must be charged (see the procedure in Maintenance chapter).
B) Without batteries
1.
Buy appropriate batteries (see the Technical Data paragraph).
2.
For battery choice and installation, apply to qualified battery Retailers.
3.
Set the machine and the battery charger according to the type of batteries (WET or GEL/ AGM), as shown in the next paragraph.
BATTERY INSTALLATION AND BATTERY TYPESETTING (WET OR GEL/ AGM)
According to the type of batteries (WET or GEL/AGM), set the machine and electronic board of the battery charger as follows:
Machine setting
When One-button Start S3 is turned off, press water volume + and - buttons (S5 and S6) at the same time, 0.5 seconds later, LED1,
LED2 and LED3 are all lit up to enter the battery mode setting:
1.
Then press water volume + or – to switch between "WET", "GEL/AMG" and "DIS-EV". In the the mode of "WET", Red light is
on. And "GEL/AGM", light is green. "DIS-EV", light is yellow.
2.
Press One-button Start to finish setting and exit, turn off machine to store and update all battery setting, when it's on, it will work
as setting.
NOTE
Default battery type is GEL/AGM.
S1
S2
LED5
LED1 LED2LED3
S3
LED4
LED6
S4
S6
LED7
Figure 4
S5
LED8
LED9
LED10
LED1
Light is Red
LED2
Light is Yellow
LED3
Light is Green
Figure 4
12
ENGLISH
WET BATTERIES
DISCOVER EV AGM BATTERIES
GENERAL GEL/AGM BATTERIES
Publicidad
